Installing a reliable and efficient security system is usually a job for professional auto engineers. Normally wires have to be cut and soldered, and holes drilled into metal. But don’t worry — our engineers have designed a system specifically for the Miata 2 that's easy to fit. No soldering, no holes to drill in metal!

The Wolfmiata system offers you the following protection:

• Opening the hood or doors will sound the siren and flash the turn signals.

• An adjustable shock sensor also sounds the alarm if your vehicle is hit.

• A microwave radar sensor protects the inside of the vehicle from intruders even if the top is down. This sensor detects mass, but is not set off by wind or vibration.

• When the alarm is set, a starter kill relay is activated.

For further convenience and protection, an optional trunk pack is also available.

(Click images for larger view.)

The first secret to installing our system is a plug-in interface harness that makes all the important power connections for you. It installs the starter kill wiring by plugging into the factory harness behind the starter switch.

In the engine bay, the siren mounts to an unused stud on the wheel arch. The engine bay is protected by a pin switch that fits to a factory-made hole.

A bright, red, flashing LED can be fitted to the top of the steering column.

The radar sensor fits under the electric window switches and simply plugs into the alarm.

All other parts bolt or wire tie into place and plug into special connectors .